RDC-5000/5300 Windows XP Installation Guide
CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. End User License Agreement...............................................................................................................3 Important notes ....................................................................................................................................4 Customer support.................................................................................................................................4 Installing the USB driver.................
1. End User License Agreement The following is a legal software license agreement between you, the software end user, and Ricoh Company Ltd. Carefully read this license agreement before using the product. Using the product indicates that you have read this license agreement and agree to its terms. Grant of License This license permits you to use one copy of the software included in this package on any single computer.
2. Important notes These instructions will guide you through the process of installing the RDC-5000/5300 USB driver and utility software on your Windows XP computer. Be sure to read, understand, and observe all precautions and requirements prior to attempting these procedures. If you feel you need assistance, please contact our customer support network at the URL listed in the Customer support section below.
After connecting the RDC-5000/5300 to your computer (1) Turn the camera mode dial to PC and move the power switch to the ON position. (2) The Found New Hardware Wizard should appear. When it does, select “Install from a list or specific location (Advanced)” and click Next. (See Figure 2.) (3) In the screen that follows, make sure “Search for the best driver in these locations” is selected, then click Browse and browse to the folder where you stored the files.
5. Installing the utility software I. Prior to installation (1) Save any important data you may be using and then quit all running applications. II. Installation procedure (1) Browse to the folder where you stored the downloaded files. (2) Click on the setup.exe icon to start the setup process. (3) Click on the Next button at the Welcome screen. (4) Type your name and company at the prompt and click Next.
8. Uninstalling RDC-5000/5300 software and drivers I. Uninstalling the utility software (1) Click on the Add or Remove Programs icon in your Control Panel. (2) Select the camera utility and click Change/Remove. (3) Click Yes to confirm that you want to uninstall this software. (4) Click OK when the unInstallShield finishes the uninstallation. II. Uninstalling the USB driver (1) Connect the camera to the computer via the USB cable, turn the mode dial to PC, and move the power switch to the ON position.