Service manual

DRAM SIMM
SM 3-11 B358
Installation
3.5 DRAM SIMM
3.5.1 REQUIRED SPECIFICATION CHECK
Before installing the DRAM SIMM, check that it satisfies the requirements below.
Type PC Compatible
Number of bins 72 pins
Access speed 70 ns or faster
Capacity 8, 16, or 32 MB
Parity Any OK
3.5.2 INSTALLATION PROCEDURE
!
CAUTION
Unplug the copier power cord before starting the following procedure.
NOTE:
If installing this DRAM SIMM and the printer controller (B358) at the same
time, skip step 1.
1. Remove the plate [A] (4 screws) and the printer controller [B] (2 screws).
2. Install the DRAM SIMM [C], as shown.
NOTE:
Make sure that the DRAM SIMM is installed properly.
3. Install the printer controller in the mainframe (refer to the Printer Controller
Installation Procedure).
4. Reattach the plate [A].
B358I553.WMF
B358I593.WMF
[C]
[A]
[B]