Service manual

POSTSCRIPT KIT
SM 3-9 B358
Installation
3.3 POSTSCRIPT KIT
3.3.1 INSTALLATION PROCEDURE
!
CAUTION
Unplug the copier power cord before starting the following procedure.
NOTE:
If installing this PostScript Kit and the printer controller (B358) at the same
time, skip steps 1 and 2.
1. Remove the plate [A] (4 screws).
2. Remove the printer controller [B] (2 screws).
3. Install the PostScript kit [C], as shown.
NOTE:
Make sure that the PostScript kit is set properly.
4. Install the printer controller into the mainframe (refer to the Printer Controller
Installation Procedure).
5. Reattach the plate [A].
6. Attach the PostScript decal [D] to the front cover, as shown.
A854I503.WMF
A854I550.WMF
A854I501.WMF
[C]
[D]
[A]
[B]