Service manual

HARD DISK
B358 3-8 SM
3.2 HARD DISK
3.2.1 INSTALLATION PROCEDURE
!
CAUTION
Unplug the copier power cord before starting the following procedure.
NOTE:
If installing this hard disk drive and the printer controller (B358) at the same
time, skip steps 1 and 2.
1. Remove the plate [A] (4 screws).
2. Remove the printer controller [B] (2 screws).
3. Attach the HDD brackets [C] to the hard disk drive [D] as shown (2 screws
each).
4. Connect the cable [E] to the hard disk drive.
5. Attach the hard disk drive to the printer controller (4 screws, 1 connector).
6. Install the printer controller into the mainframe (refer to the Printer Controller
Installation Procedure).
7. Reattach the plate [A].
8. After turning on the main switch and pressing the printer key, you will be
prompted to format the disk drive.
Press the
"
key twice to format the disk.
9. After formatting the hard disk, turn the main switch off and on.
A853I506.WMF
A853I553.WMF
[A]
[B]
[C]
[D]
[E]
[C]