Service manual

PRINTER CONTROLLER
B358 3-6 SM
Perform steps 24 to 26 only if the optional bridge unit has been installed.
If it has not been installed, go on to step 27.
24. Remove the connector cover [A] and bridge unit [B] (2 screws, 2 connectors).
25. Open the right cover [C] of the bridge unit and peel off the black tape [D], then
pull out the connector [E].
26. Install the paper sensor [F] (1 screw, 1 connector) and reinstall the bridge unit.
27. Remove the bottom cap [G] of the operation panel.
NOTE:
If both the Scanner Option Type 450e and Fax Option Type 450e have
not been installed, remove the top cap of the operation panel as well.
28. Install the
Printer
key [H] on the operation panel as shown.
NOTE:
If both the Scanner Option Type 450e and Fax Option Type 450e have
not been installed, install the
Copy
key on the operation panel as well
(see the illustration).
B358I518.WMF
B358I517.WMF
Copy
Printer
B358I501.WMF
[A]
[B]
[C]
[D]
[E]
[F]
[G]
[H]