Service manual

PRINTER CONTROLLER
B358 3-4 SM
Paper Height Sensor Installation
12. Remove the connector covers [A] and lower rear cover [B] (4 screws, 3
connectors).
13. Pull out the two paper trays [C].
14. Install edge clamps [D] in both openings [E].
15. Connect the four paper height sensors [F] to the cable [G].
16. Connect the cable to CN234 of the PCB [H].
17. Pass the two sensors attached to the white connector [I] through the upper
opening. Pass the other two sensors attached to the red connector [J] through
the lower opening. Secure the cables in place with the edge clamps attached in
step 14.
18. Install the four paper height sensors [K] from the front side of the machine, as
shown.
19. Install the four cable clamps [L], then clamp the cables.
B358I510.WMF
B358I511.WMF
B358I512.WMF
B358I513.WMF
[B]
[D]
[E]
[F]
[G]
[H]
[E]
[F]
[L]
[L]
[A]
[C]
[I]
[K]
[J]
[K]
[L]
[L]