Service manual

FEATURES
B358 2-6 SM
2.4.3 STAPLING
Stapling is only available when the 3,000-sheet finisher or 1,000-sheet finisher is
installed.
The finishers have the following stapling positions.
1) Upper left, diagonal
2) Upper right, diagonal
3) Left, two staples
4) Top, two staples
5) Right, two staples
6) Upper left, horizontal
7) Upper right, horizontal
8) Upper left, vertical
9) Upper right, vertical
NOTE:
With the 1,000-sheet finisher, only stapling positions 1) and 2) are
available.
Depending on the paper orientation, the image may have to be rotated. This image
rotation is done by the co-processor in the printer controller.
There is a limit for the number of sheets which can be stapled by each finisher. If a
job that specifies stapling has more than this number of sheets, it will not be
stapled.
2.4.4 PUNCHING
Punching is only available when the punch unit is installed with the 3,000-sheet
finisher. The number of holes depends on the type of punching unit. The punching
unit has only one available position, so the relationship between the punching
position and the printed image depends on the paper feeding orientation and
imaging. The punching positions are defined as follows.
1) Left
2) Top
3) Right