Owner`s manual

Chapter 7 - 19
Note: This will cause the Telnet connection to be broken. It is advisable to make all
other desired changes before changing the IP address.
1. At the Main Menu, type 1 and press the ENTER key to bring up the IP Parameters
menu (shown on the next page).
2. Type 1 again and press the ENTER key. The IP Address submenu will appear:
The Configuration Utility
Unit Serial no. 991398 v2.18
IP Parameters
1. IP Address
2. Subnet Mask
3. Default Gateway
4. Base Port Number
Please Enter Selection (? for Help) :
3. Enter a new IP Address and press the ENTER key. Repeat the previous steps to
change Subnet Mask and Default Gateways.
4. Enter 4 to change the base port number.
Note: The base port number is one less than the actual TCP/IP port number used
by the printer. For example, to set the port number to 9100, enter 9099. You should
specify a port number between 1000 and 65530 for compatibility with HTML-based
configuration capability, which can be accessed via the MAP or a standard Web
Browser.
7.6.3 Select Printer Languages
Selection 2 in the Main Menu allows you to designate which emulations (printer
interpreter languages) the printer supports. This is to allow the resident lpd/lpr to modify
files intended for other emulations so that they may be printed. The menu also allows you
to enable or disable banners attached to lpd/lpr handled jobs.
The emulation choices are Printer Control Language (PCL), PostScript (PS), ASCII
(simple text) and Other (any print job not recognized as PCL, PS, or ASCII). The file
modifications and conditions are:
Print Server Setup Job Detected to be Action