Owner`s manual

Chapter 4 - 14
Note: If you do not have Acrobat Reader 3.0x or higher installed, then you
should click on "Install Acrobat Reader" first.
3. Click on Installation/Configuration Programs.
4.
Click on NWSetup Software.
5.
Read the information screen. Click where indicated to start the installation.
4.6.2 How To Initiate NWSetup
When you install NWSetup, a program icon is placed on your desktop. Click on the
NWSetup icon to start the program.
Note: If you are configuring for NDS (Directory Services), make sure you are
logged into the correct tree and context before you initiate this program.
4.6.3 Using the NWSetup Program
4.6.3.1 Select a Print Server
NWSetup displays a list of all Network Interface Boards available on your network after
you initiate the program. The Network Interface Board appears with its serial number.
See screen example below:
Once you select the Network Interface Board you want to configure, the Print Server
Settings screen appears. This screen lets you set up your version of Novell NetWare for
the Network Interface Board. See 4.6.3.2 Setup Novell NetWare.
4.6.3.2 Setup Novell NetWare
The Print Server Settings screens are shown below. There are two Print Server Settings
screens, which you need to complete to configure the Network Interface Board for Novell
NetWare.
Each screen lets you set up your version of Novell NetWare for the Network Interface
Board, including directory and bindery services. A description of the fields immediately
follows each screen example.