Owner`s manual

Chapter 4 - 13
servers, you must set up a NOTIFY list for each file server. To set up NOTIFY, use the
following procedures:
1.
Start the PCONSOLE utility.
2.
Select Print Server Information from the Available Options menu.
3.
Select the print server from the menu.
4.
Select Print Server Configuration from the menu.
5.
Select Notify List for Printer from the menu.
6.
Select the printer from the Defined Printers menu.
7.
Press the ESC key at the File Server/Notify Name/Notify Type/First/Next screen.
The Notify Candidates screen appears.
8. Select the user or user group from the Notify Candidates screen.
The Notify Intervals screen displays.
9. Set the First and Next intervals for notifying users about printer problems.
è The First interval is the number of seconds the network waits before it notifies
users about a print job problem.
è The Next interval specifies how often in seconds users are notified. Enter a
number for each interval and press the ENTER key.
10.
Press the ESC key and save all changes.
11.
Press the ESC key until you see the prompt to exit PCONSOLE.
12.
Select Yes and then press the ENTER key.
4.6 NWSetup: NetWare and Print Server
Configuration Program
NWSetup lets you do the entire setup procedure for Novell NetWare and your Network
Interface Board using only one program. This program combines the following
configuration steps:
Ÿ Lets you set up the Novell file servers and print servers for NetWare printing, instead
of using NetWare utilities.
Ÿ Allows you to set up your print server printers fsor network printing.
4.6.1 How To Install
In order to install NWSetup, you must do the following:
1.
Place the CD ROM into your CD drive.
2.
Click on CD ROM Table of Contents when the menu appears.