Owner`s manual

Chapter 3 - 3
The hop count number determines how many subnetworks the program will search to
find units. An entry of 0 on the screen searches only the current subnet. An entry of 2
would search the wire directly connected to the workstation, and, all networks accessible
through two routers. Entries of 15 or higher will automatically search every connected
network (this number is not recommended due to the amount of traffic it will generate).
Once the search parameters and a hop count is entered, click on OK.
3.5 Web IP Browser
Once you have assigned an IP address to your Network Interface Board, you may use an
IP browser, such as Netscape, to access the HTTP Server and the HTML code allowing
Network Interface Board monitoring and maintenance. To access the HTTP Server
screens from your browser, do the following:
1.
Open up your browser by clicking on its icon.
2.
For the URL, type in the IP address of the Network Interface Board (ex.
http://123.456.789.123). The HTTP Server screens should appear.
If you have problems, check to make sure you are using the correct IP address.