Owner's Manual Network Guide

Connecting and Setting Up
50
2
LDAP Server Settings
Program the LDAP server to find up
e-mail destinations in the LDAP serv-
er Address Book directly. This func-
tion is possible when sending scan
files by e-mail using the scanner or
fax function, or when entering au-
thentication information.
Before using this function
To start an LDAP search, make sure
that the items listed below are set. For
other items, check your environment
and make any necessary changes.
• Server Name
• Search Base
• Port No.
• Search Conditions
• Authentication method selection
Note
❒ For authentication method, se-
lect from [High Security], [On], or
[Off].
• User Name/Password
The settings above differ depend-
ing on server environment. Check
your environment and make any
necessary changes.
Note
❒ To use the LDAP server in Admin-
istrator Tools, select [On] under
[LDAP Server].
❒ This function supports LDAP Ver-
sion 2.0 and 3.0. Ver 2.0 does not
support High Security authentica-
tion.
Program/Change/Delete LDAP
Server
To enter Program/Change/Delete
LDAP Server
A
Press the {User Tools/Counter/Inquiry}
key.
B
BB
B
Press [System Settings].
C
Press [Administrator Tools], and then
press [TNext] twice.
D
DD
D
Press [Program / Change / Delete LDAP
Server].
To program/change the LDAP
server
A
AA
A
Select the LDAP server you want
to program or change.
When programming the server, se-
lect [*Not Programmed].
B
BB
B
Set each item as necessary.