Owner's Manual Network Guide
Table Of Contents
- Network Guide
- TABLE OF CONTENTS
- Manuals for This Machine
- How to Read This Manual
- 1. Getting Started
- 2. Connecting and Setting Up
- 3. Using a Printer Server
- 4. Monitoring and Configuring the Printer
- Using Web Image Monitor
- Using SmartDeviceMonitor for Admin
- Installing SmartDeviceMonitor for Admin
- Changing the Network Interface Board Configuration
- Locking the Menus on the Machine's Control Panel
- Changing the Paper Type
- Managing User Information
- Configuring the Energy Saver Mode
- Setting a Password
- Checking the Machine Status
- Changing Names and Comments
- Load Fax Journal
- Viewing and Deleting Spool Print Jobs
- Managing Address Information
- Using SmartDeviceMonitor for Client
- Remote Maintenance by telnet
- SNMP
- Getting Printer Information over the Network
- Understanding the Displayed Information
- Message List
- 5. Special Operations under Windows
- 6. Appendix
- INDEX
Connecting and Setting Up
12
2
Confirming the Connection
A
AA
A
Make sure the LED of the IEEE
802.11b interface unit is lit.
❖ When using in infrastructure mode
1. If [LAN Type] on the [Interface Set-
tings]/[Network] screen is not set to
[IEEE 802.11b], it does not light, even
if the main power is on.
2. If it is connected properly to the
network, the LED is green when in
infrastructure mode. If the LED is
blinking, the machine is searching
for devices.
❖ When using in ad hoc mode/802.11
ad hoc mode
1. If the IEEE 802.11b interface unit
is working, it is lit in orange.
2. If it is connected properly to the
network, the LED is green when in
ad hoc mode or 802.11 ad hoc mode.
If the LED is blinking, the machine
is searching for devices. The LED
will light after a few seconds.
B
BB
B
Print the configuration page to
verify settings.
Reference
For more information about
printing a configuration page,
see Printer Reference.
ZZZ024S
1
2
ZZZ024S
1
2