Owner's Manual Network Guide
Table Of Contents
- Network Guide
- TABLE OF CONTENTS
- Manuals for This Machine
- How to Read This Manual
- 1. Getting Started
- 2. Connecting and Setting Up
- 3. Using a Printer Server
- 4. Monitoring and Configuring the Printer
- Using Web Image Monitor
- Using SmartDeviceMonitor for Admin
- Installing SmartDeviceMonitor for Admin
- Changing the Network Interface Board Configuration
- Locking the Menus on the Machine's Control Panel
- Changing the Paper Type
- Managing User Information
- Configuring the Energy Saver Mode
- Setting a Password
- Checking the Machine Status
- Changing Names and Comments
- Load Fax Journal
- Viewing and Deleting Spool Print Jobs
- Managing Address Information
- Using SmartDeviceMonitor for Client
- Remote Maintenance by telnet
- SNMP
- Getting Printer Information over the Network
- Understanding the Displayed Information
- Message List
- 5. Special Operations under Windows
- 6. Appendix
- INDEX
Precautions
143
6
NetWare Printing
Form feed
You should not configure form feed
on NetWare. Form feed is controlled
by the printer driver on Windows. If
NetWare form feed is configured, the
printer might not work properly. If
you want to change form feed set-
tings, always configure them using
Windows.
• Under Windows 95/98/Me, clear
the [Form feed] check box on the
[Printer Settings] tab in the printer
properties dialog box.
• Under Windows 2000/XP and Win-
dows Server 2003, clear the [Form
feed] check box on the [NetWare Set-
tings] tab in the printer properties di-
alog box.
• Under Windows NT 4.0, clear the
[Form feed] check box on the [Net-
Ware Settings] tab in the printer
properties dialog box.
Banner page
You should not configure a banner
page on NetWare. If you want to
change the banner page setting, al-
ways configure it using Windows.
• Under Windows 95/98/Me, clear
the [Enable banner] check box on the
[Printer Settings] tab in the printer
properties dialog box.
• Under Windows 2000/XP and
Windows Server 2003, clear the
[Enable banner] check box on the
[NetWare Settings] tab in the printer
properties dialog box.
• Under Windows NT 4.0, clear the
[Enable banner] check box on the
[NetWare Settings] tab in the printer
properties dialog box.
Printing after resetting the machine
After resetting the remote printer, the
connection from the print server will
be cut off for about 30-40 seconds be-
fore re-connecting. Depending on the
NetWare specification, print jobs may
be accepted, but they will not be
printed during this interval.
When using the machine as a remote
printer, wait about two minutes after
resetting before attempting to print.