Owner's Manual Network Guide
Table Of Contents
- Network Guide
- TABLE OF CONTENTS
- Manuals for This Machine
- How to Read This Manual
- 1. Getting Started
- 2. Connecting and Setting Up
- 3. Using a Printer Server
- 4. Monitoring and Configuring the Printer
- Using Web Image Monitor
- Using SmartDeviceMonitor for Admin
- Installing SmartDeviceMonitor for Admin
- Changing the Network Interface Board Configuration
- Locking the Menus on the Machine's Control Panel
- Changing the Paper Type
- Managing User Information
- Configuring the Energy Saver Mode
- Setting a Password
- Checking the Machine Status
- Changing Names and Comments
- Load Fax Journal
- Viewing and Deleting Spool Print Jobs
- Managing Address Information
- Using SmartDeviceMonitor for Client
- Remote Maintenance by telnet
- SNMP
- Getting Printer Information over the Network
- Understanding the Displayed Information
- Message List
- 5. Special Operations under Windows
- 6. Appendix
- INDEX
Message List
131
4
SMTPC: no smtp server. connection close. Connection to the SMTP server failed due to
no response from SMTP. This could be be-
cause:
• A server other than the SMTP server has
been specified.
• The specified SMTP server port number is
incorrect.
SMTPC: failed to connect smtp server. Connection to the SMTP server failed. This
could be because:
• No connection to the network has been es-
tablished.
• The network configuration is incorrect, so
there is no response from the SMTP server.
• The specified SMTP server name is incorrect.
• An incorrect SMTP server is specified.
• The specified SMTP server IP address
could not be found in the DNS server.
• A server other than the SMTP server has
been specified.
• The specified SMTP server port number is
incorrect.
SMTPC: username or password wasn’t cor-
rect. [response code] (information)
Connection to the SMTP server failed. This
could be because:
• The specified SMTP user name is incorrect.
• The specified SMTP password is incorrect.
Check the SMTP user name and password.
Snmp over ip is ready. Communication over TCP/IP with snmp is
available.
Snmp over IP over 1394 is ready. Communication over IP over 1394 with snmp
is available.
Snmp over ipx is ready. Communication over IPX with snmp is available.
SNMPD: account is unavailable:
Same account name be used.
User account is disabled. This could be be-
cause it use the same account name as the ad-
ministrator account.
SNMPD: account is unavailable:
The authentication password is not set up.
User account is disabled. This could be be-
cause the authentication password is not set,
and only the encryption account is set.
SNMPD: account is unavailable:
encryption is impossible.
Encryption is not possible and account is disa-
bled. This could be because:
• Security option is not installed.
• Encryption password has not been speci-
fied.
SNMPD: trap account is unavailable. v3Trap cannot be sent. This could be because
the Trap destination account is different from
the account specified by the printer.
Message Problem and solutions