Owner's Manual Network Guide

Monitoring and Configuring the Printer
110
4
wins
Use the "wins" command to configure
WINS server settings.
❖
❖❖
❖ Viewing settings
msh> wins
• If the IP address obtained from
DHCP differs from the WINS IP
address, the DHCP address is
the valid address.
❖
❖❖
❖ Configuration
msh> wins “interface_name”
{on | off}
• {on} means "active" and {off}
means "inactive".
• Be sure to specify the interface.
• ip1394 can be specified only
when the IEEE 1394 interface is
installed.
• wlan can be specified only
when the IEEE 802.11b interface
is installed.
❖
❖❖
❖ Address configuration
Use the following command to
configure a WINS server IP ad-
dress:
msh> wins “interface_name”
{primary|secondary} “IP ad-
dress”
• Use the “primary” command to
configure a primary WINS serv-
er IP address.
• Use the "secondary" command
to configure a secondary WINS
server IP address.
• Do not use “255.255.255.255” as
the IP address.
❖
❖❖
❖ NBT (NetBIOS over TCP/IP) Scope ID
Selection
You can specify the NBT scope ID.
msh> wins
“interface_name” scope
“scope ID”
• The scope ID can be entered us-
ing up to 31 alphanumeric char-
acters.
• Be sure to specify the interface.
• ip1394 can be specified only
when the IEEE 1394 interface is
installed.
• wlan can be specified only
when the IEEE 802.11b interface
is installed.
Interface name Interface configured
ether Ethernet interface
ip1394 IEEE 1394 interface
wlan
IEEE 802.11b interface
Interface name Interface configured
ether Ethernet interface
ip1394 IEEE 1394 interface
wlan
IEEE 802.11b interface