Specifications

Checking imprinting After shooting, the imprint mark--flickers in the display panel for a few seconds for correct
imprinting. The mark and the letter "M" are not imprinted on the picture.
Resetting the date and time (Figs. 30A - C) 1. Each time the Selector button is pressed the flashing digits change
in the order of year, month, day, hour, minute and colon (:). 2. When the digits to be reset flash, press the Set
button until the desired digits appear. When the Set button is kept pressed, the digits change rapidly.
Accurately seeing seconds (Figs. 31 A - C)
1. Press the Mode selector button for Time display mode.
2. Press the Selector button so that the colon (:) flickers.
3. Press the Set button according to the radio or telephone time signal. The time count starts form 0 seconds.
* It is recommended that the second digits be adjusted after adjusting the minute digits.
Battery Replacement
The date/time function draws power from the camera battery. For detailed information on the battery, refer to the
page 12. When replacing the battery, if the display does not blank out, setting the date and time after battery
replacement is not necessary. But if there is nothing on the display, set the date and time after installing new
battery. Note that even when the battery is removed, the display data will be retained for several minutes.
Notes on the date imprinting feature
* At temperature of below 0 C (32 F), the battery performance deteriorates. The date imprinting feature may not
function correctly and imprinting may become impossible.
* When the battery is replaced, the display panel sometimes shows wrong digits. Reset the digits for correct
indication.
* The date is sometimes illegible if it is imprinted on the following objects.