Specifications

a. The shutter cannot be released (apart from when the Lens Shield is closed).
b. The Flash Ready Lamp takes more 30 seconds to light up.
c. The Film Advance or Film Rewind does not operate.
LOADING THE FILM
Always avoid direct sunlight when loading the film.
1. Push the Back Cover Latch downward to open. (Fig. 8)
2. Load the film into the Film Chamber and pull out the film leader. (Fig. 9) Press the film cassettes outlet so that
the surface becomes level with the rail surface, and place the film leader over the Film Leader Mark. (Fig. 10)
3. Line up the film within the Film Guides. Make sure that there is no slack in the film and that the edge of the film
stays over the Film Counter Switch. (Fig. 11)
4. Press the Back Cover shut so that the Back Cover Latch returns to its original position. The film is automatically
advanced until number "1" appears in the Film Counter Window. (Fig. 12)
5. If number 1 does not appear in the Film Counter Window, the film has not advanced correctly. The motor may
not stop. Reload the film by following steps 1 - 4 shown above.
4www.butkus.or g
* Whether there is film in your camera or not can be confirmed by the Film Loaded Window. (Fig. 13)
* Do not use special-purpose films such as 35mm Instant Reversal Film, etc. because your camera may not be able
to transport and expose them properly,
* You can load film in your camera with the Lens Shield closed.