Specifications

1. Insert the small loop at the end of the Strap under the Strap Holder. (Fig. 1)
2. Insert the other end of the Strap through the loop to tie the Strap onto the Strap Holder. (Fig. 2)
INSERTING THE BATTERY
The camera will not operate unless the battery is installed. It is important to make sure that the battery is installed
correctly.
1. Use a pen to push the battery Compartment Cover Latch in the direction of the arrow and pull open the cover.
(Fig. 3)
2. Insert either a 3 volt lithium battery or 2 AA-size alkaline/manganese batteries, checking that + and - the battery
are lined up correctly according to the polarity diagram inside the battery compartment. (Fig. 4)
3. Close the battery Compartment Cover by pushing it in the direction of the arrow. (Fig. 5)
* When replacing the battery do so as quickly as possible, and avoid having film inside the camera.
* Please finish any roll of film in your camera and then remove the battery from the camera when you do not use
the camera for a long period of time.
Battery for use
Lithum battery (3V) (Panasonic CR-123A, Duracell DL-123A) or 2 Alkaline penlight batteries or 2 Manganese
penlight batteries (Nickel Cadmium can not be used.)4www.butkus.org
OPENING THE LENS SHIELD
1. Slide the Lens Shield in the direction of arrow to open. (Fig. 6)
* You can only take pictures when the Lens Shield is completely open.
* To avoid tripping the shutter inadvertently and wasting film or battery power, always keep the Lens Shield
closed when you are not taking pictures.
* Opening the Lens Shield while pressing the shutter release will release the shutter.
* When opening the Lens Shield the Flash Unit is automatically supplied with power, and the Flash Ready Lamp is
turned ON. This to make sure that the Flash is ready to be used whenever necessary
CHECKING THE BATTERY
1. Cover the Photocell with your hand and press the Shutter Release Button down halfway.
2. If the Low Light Warning LED lights, then the battery power is sufficient. (Fig. 7)
3. If the low light warning LED does not light the battery is insufficient or the battery is not inserted correctly into
the battery compartment. Replace the battery or re-insert the battery according to the polarity diagram inside the
battery compartment.4www.butkus.o rg
* Generally, in cold conditions, the capacity of the battery decreases, and in some cases, the camera may not
operate correctly. You should either warm the battery or keep a spare in your pocket, inserting them just before
you use the camera. If the capacity of the battery has decreased in cold temperatures, it usually will regain full
capacity in normal temperatures. Do not throw the battery away without checking it.
* If the battery voltage is insufficient, the shutter may not release or the film may not advance completely. In the
following cases, replace the battery