Setup guide

ScanRouter V2 Lite Installation
12
3
Uninstalling ScanRouter V2 Lite
This section explains how to uninstall
ScanRouter V2 Lite.
The contents of the RDCab folder re-
main after ScanRouter V2 Lite is unin-
stalled.
Important
❒ Before uninstallation, be sure to
back up the system and various
data. Stop the delivery server from
the ScanRouter V2 Administration
Utility.
Note
❒ ScanRouter V2 Lite cannot be un-
installed when network devices
are configured in [Set I/O Device]. To
uninstall ScanRouter V2 Lite, de-
lete all the network devices set in
[Set I/O Device] first.
A
Exit the ScanRouter V2 Adminis-
tration Utility.
B
Select ScanRouter V2 Lite in [Add
and Delete Application] on the con-
trol panel, and then select [Add and
Delete] or [Change/Delete].
The "InstallShield Wizard" dialog
box appears.
C
Select "Delete" and then select
[Next].
The Confirmation dialog box ap-
pears.
D
Select [OK].
E
Select if setting information such
as a destination is deleted.
ScanRouter V2 Lite has been unin-
stalled and "Exit of Maintenance"
appears.
Note
❒ If you are asked to delete a file
which may be shared with other
programs, select [No].
F
Select [Complete].
Note
❒ If only ScanRouter V2 Lite is in-
stalled in a computer, you can
delete the RDCab folder (or a
folder specified as a data
path)⇒ P.7 “ScanRouter V2 Lite
Installation”. If DeskTopBinder
V2 or ScanRouter V2 Link is in-
stalled in the same computer,
however, do not delete the RD-
Cab folder (or a folder specified
as a data path). If you want to
delete the data in ScanRouter
V2 Lite, delete the DR folder
and the DRTmp folder in the
RDCab folder (or a folder speci-
fied as a data path)