Setup guide

Installing ScanRouter V2 Administration Utility in a Client Computer
11
3
F
Enter a folder for an installation
destination and select [Next].
Note
❒ If DeskTopBinder V2 or Scan-
Router V2 Link is already in-
stalled, you cannot specify the
installation destination because
it will be a common folder. "Se-
lect Installation Destination"
does not appear.
❒ You cannot specify the follow-
ing locations:
• Folders in which Windows is
installed
• Root Directory
• Within removal media such
as MO disk
G
Confirm the contents of registra-
tion.
When [OK] is selected, the Scan-
Router V2 Administration Utility
is installed.
Dial-up-related Device
When the dial-up router is connected in
an environment in which ScanRouter V2
is used
Appropriately perform the settings
below. If the network environment is
changed, perform the settings again.
The delivery server must be set up.
• network device
• ScanRouter V2 Administration
Utility
• ScanRouter V2 Link
• DeskTopBinder V2
A network device must be set up.
• delivery server (set up in the set-
ting of I/O devices of ScanRouter
V2 Administration Utility)
Important
❒ If the delivery server is connected
when a connection to the delivery
server via the dial-up router is set,
the line may be connected and tele-
phone charges may be collected.
When you use a dial-up connection
computer
When the ScanRouter V2 Administra-
tion Utility, DeskTopBinder V2, or
ScanRouter V2 Link is used in the
dial-up connection computer, a dial-
up connection may be made due to
the connection to the delivery server,
depending on the setting.
Important
❒ When you set that your computer
is automatically connected to the
Internet, without displaying the
dialog box for confirming the con-
nection, the line is connected and
telephone charges occur. To avoid
the unnecessary dial-up connec-
tion, be sure to set to display con-
nection confirmation during
operation. Also, check if the unnec-
essary dial-up connection is made
when these software products are
used.