Setup guide

7
3. ScanRouter V2 Lite
Installation
Install ScanRouter V2 Lite according to the flow below.
ScanRouter V2 Lite Installation
Install ScanRouter V2 Lite according
to the procedure below.
Make sure that you have all finished
preparing for the server to be installed.
Important
❒ After installation is complete, be
sure to restart the computer. If
ScanRouter V2 Lite is launched be-
fore relaunching the computer, it
may not work normally. In this
case, reinstall ScanRouter V2 Lite.
Note
❒ When you use ScanRouter V2 Lite
in Windows NT/2000, log on Win-
dows with a launch account which
was set in “Account Settings-Win-
dows NT/2000 Only”
⇒
P.3 during
installation.
A
Display the "Set up ScanRouter
V2 Lite" dialog box of ScanRouter
V2 Lite.
B
Select [ScanRouter V2 Lite].
C
When ScanRouter is installed, se-
lect if ScanRouter data is used.
When "Yes" is selected, conversion
is performed so that address book
data in ScanRouter can be used for
ScanRouter V2 Lite.
Note
❒ Save in advance necessary data
other than the address book
data in ScanRouter in a different
location.
A dialog box for confirming instal-
lation start appears.
Specify the installation destination
ScanRouter V2 Lite Installation
Specify a folder as the
installation destination
Specify a data path
Software license agreement
Select a setup type
Restart the computer
Authorization for server access
(Windows NT/2000)