Setup guide

Installing DeskTopBinder V2 Lite

Confirm the entered information, and then click [Yes].

If the client computer is installed with DeskTopBinder, the Choose Setup

Type dialog box will appear.

Select the installation method, and then click [Next].

Select the installation location, and then click [Next].

Note

❒ When a ScanRouter V2 product is already installed, the installation loca-

tion cannot be changed. DeskTopBinder V2 Lite is installed as a common

folder with the ScanRouter V2.

Specify the locations of the documents that DeskTopBinder V2 Lite will

manage, and then click [Next].

You can change the location of documents managed by DeskTopBinder V2

Lite, but generally leave them as they are and use the RDCab folder, the

stored location folder.

In the RDCab folder, the PL folder is created. The RDCab folder must be cre-

ated in the built-in hard drive of client computers where DeskTopBinder V2

Lite is installed.

Confirm the setup details of the installation location, and then click [Next].

Click [Finish].

The installation of Job Binding and ScanRouter V2 Link follows. After that,

follow the directions that appear on the screen.

Functions of Job Binding

Job Binding is installed at the same time DeskTopBinder V2 Lite is installed.

Job Binding stores DeskTopBinder V2 Lite documents and files created by var-

ious applications as print data. Job Binding can be instructed to print just one

document, staple the saved print data onto another, print in duplex, change the

print order and so forth.

From the DeskTopBinder V2 Lite Install dialog box, installing only Job Binding

is possible.

Note

❒ Job Binding is enabled only when the RPCS printer driver is installed on the

printer.