Specifications

Troubleshooting 5-43
M M L 0 0
5.2.44. E2EE FNS SIGNAL TRANSLATION ERROR
5.2.45. E259 CONFIGURATION ERROR
Figure 5-23. Error Code E259
PRIMARY FACTOR; A translation error has occurred Finisher P/K.
PHENOMENON CAUSES & CHECK POINTS CORRECTIONS Maintenance
Ref + Page
1. This phenomenon
occurs.
1. PCB fault. Replace: FS-108H/HBM P/K
3.5, 3-7
PRIMARY FACTOR; Finisher configuration is changed.
Printer: The Printer memorizes a finisher configuration. The default of it is "Standard type".
The Printer detects the configuration error if a configuration memorized in the Printer
is different from one reported from the Finisher when powered on.
The Configuration error is automatically reset and a configuration reported from
the Finisher is automatically memorized in the Printer after the Printer is turned
OFF and ON.
Finisher: Finisher judges a connection by the following condition.
Folding unit : FS-108HBM P/K detects that the "BM SET signal" is low.
(B6 pin and B7 pin of CN5 are connected.)
Cover Sheet Feeder : FS-108H/HBM P/K detects that the "SHEET SET signal" is low.
(A24 pin of CN51 and 7 pin of CN1 are connected.)
PHENOMENON CAUSES & CHECK POINTS CORRECTIONS Maintenance
Ref + Page
1. This phenomenon
occurs.
1. Right after finisher
configuration is changed.
Turn OFF/ON the Printer
2. PCB fault. Replace: FS-108H/HBM P/K
Replace: PI-108H P/K
3.5, 3-7
3.5, 3-7
3. The breaking cables or
the disconnecting of
connectors.
Repair the cable or reset the
connector.
Finisher Configuration
1. Standard type Default
2. Standard type + Folding unit
2. Standard type + Cover Sheet Feeder
4. Standard type + Folding unit + Cover Sheet Feeder