Specifications

Troubleshooting 5-35
M M L 0 0
5.2.34. E2C9 BELT POS. ERROR
PRIMARY FACTOR; During the Paper Exit Belt operation, the Belt cannot be detected.
PHENOMENON CAUSES & CHECK POINTS CORRECTIONS Maintenance
Ref + Page
1. This phenomenon
occurs because
the Paper Exit
Belt does not
operate.
1. The drive system for the
belt operation is faulty.
Check:
Paper Exit Belt or its environs.
2. Motor fault. Replace:
Paper Exit Roller Motor (M7)
3.5, 3-7
3. The breaking of cables or
the disconnecting of
connectors.
Repair the cable or reset the
connector
CN1 - M7
4. PCB fault. Replace: FS-108H/HBM P/K
3.5, 3-7
2. This phenomenon
occurs though the
Paper Exit Belt
operates.
1. The mounting sensor is
faulty.
Reset the Sensor correctly.
Paper Exit Belt HP PS (PS9)
3.4, 3-3
2. The breaking of cables or
the disconnecting of
connectors.
Repair the cable or reset the
connector
CN25 - PS9
3. Sensor fault. Replace:
Paper Exit Belt HP PS (PS9)
3.4, 3-3
4. PCB fault. Replace: FS-108H/HBM P/K 3.5, 3-7
Refer to Figure 5-17.