Specifications

5-34 DDP92/184 Finisher Maintenance Manual

M M L 0 0

5.2.33. E2C8 SHIFT POS. ERROR

Figure 5-17. Error Codes E2C8 & E2C9

PRIMARY FACTOR; During the Shift operation, the Shift Unit cannot be detected.

PHENOMENON CAUSES & CHECK POINTS CORRECTIONS Maintenance

Ref + Page

1. This phenomenon

occurs because

the Shift Unit does

not operate.

1. The drive system for the

Shift is faulty.

Adjust: Shift position

Check: Shift or its environs.

6.2.1, 6-11

2. Motor fault. Replace:

Roller Shift Motor (M2)

3.5, 3-7

3. The breaking of cables or

the disconnecting of

connectors.

Repair the cable or reset the

connector

CN1 - M2

4. PCB fault. Replace: FS-108H/HBM P/K 3.5, 3-7

5. Shift Pulley fault. Replace: Shift Pulley

6.2.1, 6-11

2. This phenomenon

occurs though the

Shift Unit

operates.

1. The mounting sensor is

faulty.

Reset the Sensor correctly.

Roller Shift HP PS (PS18)

3.4, 3-3

2. The breaking of cables or