Specifications

Troubleshooting 5-33
M M L 0 0
5.2.32. E2C7 ALIGNMENT PLATE POS. ERROR
Figure 5-16. Error Codes E2C7 & E2E9
PRIMARY FACTOR; During the Alignment Plate/Upper operation, the plate cannot be detected.
PHENOMENON CAUSES & CHECK POINTS CORRECTIONS Maintenance
Ref + Page
1. This phenomenon
occurs because
the Alignment
Plate/Upper does
not operate.
1. The drive system for the
Alignment Plate/Upper is
faulty.
Check:
Alignment Plate/Upper or its
environs.
6.3.12, 6-46
2. Motor fault. Replace:
Alignment Plate/Upper Motor (M5) 3.5, 3-7
3. The breaking of cables or
the disconnecting of
connectors.
Repair the cable or reset the
connector
CN25 - M5
4. PCB fault. Replace: FS-108H/HBM P/K 3.5, 3-7
2. This phenomenon
occurs though the
Alignment
Plate/Upper
operates.
1. The mounting sensor is
faulty.
Reset the Sensor correctly.
Alignment Plate/Upper HP PS
(PS8)
3.4, 3-3
2. The breaking of cables or
the disconnecting of
connectors.
Repair the cable or reset the
connector
CN25 - PS8
3. Sensor fault. Replace:
Alignment Plate/Upper HP PS
(PS8)
3.4, 3-3
4. PCB fault. Replace: FS-108H/HBM P/K 3.5, 3-7