Specifications

5-28 DDP92/184 Finisher Maintenance Manual
M M L 0 0
5.2.27. E2B1 FNS COVER SHEET TRAY TIMEOUT
Figure 5-14. Error Code E2B1
PRIMARY FACTOR; Even if the Cover Sheet Tray is driven for 10 seconds, the Sheet Tray Upper Limit PS or Sheet
Tray Lower Limit PS does not detect the Tray.
PHENOMENON CAUSES & CHECK POINTS CORRECTIONS Maintenance
Ref + Page
1. Cover Sheet Tray
does not operate.
1. The breaking of Interface
cables or the disconnect-
ing of connectors.
Repair the cable or reset the
connector
CN2 (PI-108H P/K) - M201
2. Motor fault. Replace:
Sheet Tray Motor (M201)
3.5, 3-7
3. PCB fault. Replace:
PI-108H P/K
FS-108H/HBM P/K
3.5, 3-7
3.5, 3-7
2. This phenomenon
occurs though the
Cover Sheet Tray
operates.
1. Sensor is incorrectly set. Reset the Sensor correctly.
Sheet Tray Upper Limit PS
(PS204)
Sheet Tray Lower Limit PS
(PS203)
3.4, 3-3
3.4, 3-3
2. The breaking of Interface
cables or the disconnect-
ing of connectors.
Repair the cable or reset the
connector
CN51 - PS203
CN51 - PS204
3. Sensor fault. Replace:
Sheet Tray Upper Limit PS
(PS204)
Sheet Tray Lower Limit PS
(PS203)
3.4, 3-3
3.4, 3-3
4. PCB fault. Replace:
PI-108H P/K
FS-108H/HBM P/K
3.5, 3-7
3.5, 3-7