Specifications

Troubleshooting 5-23
M M L 0 0
5.2.18. E1D2 FNS LEAD JAM 3
5.2.19. E1D3 FNS LEAD JAM 4
PRIMARY FACTOR; Paper did not arrive at the Stacker Conveyance Passage PS.
PHENOMENON CAUSES & CHECK POINTS CORRECTIONS Maintenance
Ref + Page
1. This phenomenon
occurs because
the paper has not
arrive the Stacker
Conveyance
Passage PS
1. Foreign substance is on
the paper path.
Remove: Foreign substance
2. Paper contacts the gate. Position adjustment:
Sub-Tray Paper Exit Gate
Paper Path Switching Gate
6.3.3, 6-33
6.3.4, 6-35
3. The breaking of cables or
the disconnecting of
connectors.
Repair the cable or reset the
connector
CN1 - SD1
4. Solenoid fault. Replace: Gate Solenoid (SD1) 3.5, 3-7
5. PCB fault. Replace: FS-108H/HBM P/K 3.5, 3-7
2. This phenomenon
occurs though the
paper has arrive
at the Stacker
Conveyance
Passage PS.
1. The breaking of cables or
the disconnecting of
connectors.
Repair the cable or reset the
connector
CN1 - PS5
2. Sensor fault. Replace:
Stacker Conveyance Passage PS
(PS5)
3.4, 3-3
3. PCB fault. Replace: FS-108H/HBM P/K 3.5, 3-7
Refer to
Figure 5-12
PRIMARY FACTOR; Paper did not arrive at the Paper Exit 1 PS.
Note ; E1D3 is detected on Staple Mode of the following paper. Letter (LEF), A4 (LEF), B5 (LEF)
PHENOMENON CAUSES & CHECK POINTS CORRECTIONS Maintenance
Ref + Page
1. This phenomenon
occurs because
the paper has not
arrive the Paper
Exit 1 PS.
1. Foreign substance is on
the paper path.
Remove: Foreign substance
2. This phenomenon
occurs though the
paper has arrive
at the Paper Exit 1
PS.
1. The breaking of cables or
the disconnecting of
connectors.
Repair the cable or reset the
connector
CN1 - PS6
2. Sensor fault. Replace:
Paper Exit 1 PS (PS6) 3.4, 3-3
3. PCB fault. Replace: FS-108H/HBM P/K 3.5, 3-7
4. Shift Pulley fault. Replace: Shift Pulley
6.2.1, 6-11
Refer to Figure 5-12