Specifications

5-20 DDP92/184 Finisher Maintenance Manual
M M L 0 0
5.2.11. E1C5 FNS LEAD JAM 8
5.2.12. E1C6 FNS TRAIL JAM 7
5.2.13. E1C7 FNS INSERTER JAM 1
PRIMARY FACTOR; Paper did not arrive at the Folding Passage PS/2.
PHENOMENON CAUSES & CHECK POINTS CORRECTIONS Maintenance
Ref + Page
1. This phenomenon
occurs because
the paper has not
arrive the Folding
Passage PS/2.
1. Foreign substance is on
the paper path.
Remove: Foreign substance
2. PCB fault. Replace: FS-108H/HBM P/K
3.5, 3-7
2. This phenomenon
occurs though the
paper has arrive
at the Folding
Passage PS/2.
1. The breaking of cables or
the disconnecting of
connectors.
Repair the cable or reset the
connector
CN9 - PS26
2. Sensor fault. Replace:
Folding Passage PS/2 (PS26)
3.4, 3-3
3. PCB fault. Replace: FS-108H/HBM P/K 3.5, 3-7
Refer to Figure 5-12
PRIMARY FACTOR; Paper did not depart from the Folding Paper Exit PS.
PHENOMENON CAUSES & CHECK POINTS CORRECTIONS Maintenance
Ref + Page
1. This phenomenon
occurs because
the paper has not
depart from the
Folding Paper Exit
PS.
1. Foreign substance is on
the paper path.
Remove: Foreign substance
2. The breaking of cables or
the disconnecting of
connectors.
Repair the cable or reset the
connector
CN8 - M20
3. Motor fault. Replace:
Folding Conveyance Motor (M20) 3.5, 3-7
4. PCB fault. Replace: FS-108H/HBM P/K 3.5, 3-7
Refer to Figure 5-12
PRIMARY FACTOR; Paper did not arrive at the Sheet Passage PS in the Cover Sheet Feeder use.
PHENOMENON CAUSES & CHECK POINTS CORRECTIONS Maintenance
Ref + Page
1. This phenomenon
occurs because
the paper has not
arrive the Sheet
Passage PS.
1. Foreign substance is on
the paper path.
Remove: Foreign substance
2. PCB fault. Replace: FS-108H/HBM P/K
3.5, 3-7
2. This phenomenon
occurs though the
paper has arrive
at the Sheet
Passage PS.
1. The breaking of cables or
the disconnecting of
connectors.
Repair the cable or reset the
connector
CN51 - PS201
2. Sensor fault. Replace:
Sheet Passage PS (PS201)
3.4, 3-3
3. PCB fault. Replace: FS-108H/HBM P/K 3.5, 3-7
Refer to Figure 5-12