Specifications

5-4 DDP92/184 Finisher Maintenance Manual
M M L 0 0
5.1.3. Flat Stapling position failure
Figure 5-1. Flat Stapling position failure
5.1.4. Staple orientation failure on center stapling/folding mode
PRIMARY FACTOR; The flat stapling position on the paper is beyond the requirements.
NOTE: The Finisher has a possibility that this phenomenon may occur 1 time
per 200 staple operations.
PHENOMENON CAUSES & CHECK POINTS CORRECTIONS Maintenance
Ref + Page
1. This phenomenon
occurs continuou-
sly.
1. The space "A" is not in
the requirement.
Adjust: Flat Stapling stopper
6.3.16, 6-50
Spec range: A=5.5 to 11.5mm
(initial value=8.5mm)
PRIMARY FACTOR; The staple orientation is not parallel with the paper edge.
PHENOMENON CAUSES & CHECK POINTS CORRECTIONS Maintenance
Ref + Page
1. This phenomenon
occurs.
1. The Staplers are not
parallel with the paper
feed direction.
Adjust:Staple orientation
6.3.18, 6-54