Specifications

Troubleshooting 5-3
M M L 0 0
5.1.2. Stapling failure
PRIMARY FACTOR;
(a) The staple does not reach the tip of the Staple Cartridge.
NOTE: The Finisher has a possibility that this phenomenon may occur 5
times per 1,000 staple operations.
(b) The staple remains at the tip of the Staple Cartridge.
NOTE: The Finisher has a possibility that this phenomenon may occur 1
time per 1,000 staple operations.
(c) The staple is folded.
NOTE: The Finisher has a possibility that this phenomenon may occur 5
times per 1,000 staple operations.
(d) The gap between the paper and a staple is beyond 1mm.
NOTE: The Finisher has a possibility that this phenomenon may occur 5
times per 1,000 staple operations.
PHENOMENON CAUSES & CHECK POINTS CORRECTIONS Maintenance
Ref + Page
1. No staple on the
paper.
1. The staple does not reach
the tip of the Staple
Cartridge housing.
(E019/E01A error does
not occur.)
Replace: Stapler
4.3.3, 4-7
2. The staple remains at the
tip of the Staple Cartridge
housing.
Replace: Staple Cartridge housing
Stapler
4.3.3, 4-7
2. A staple on the
paper.
1. The staple is folded. Replace: Stapler 4.3.3, 4-7
2. The gap between the
staple and the paper is
more than 1mm.
Replace: Stapler 4.3.3, 4-7
or
Less than 1mm