Specifications

Preventive Maintenance 4-1
M M L 0 0
Chapter 4. Preventive Maintenance
This section contains information for maintaining the finisher for continuous failure-
free, high quality performance. Including in this section are procedures for cleaning the
exterior and interior of the finisher.
While performing any maintenance procedure, visually inspect the finisher for loose,
broken or missing cables, connectors or other parts.
PREVENTIVE MAINTENANCE SCHEDULE
For many of the preventive maintenance procedures, there are no set times to perform
them. The determining factor for when to perform a procedure depends on the extent
of use. Finishers that are used more heavily will require more frequent preventive
maintenance.
4.1. Periodic check and Cleaning by Customer Engineer
This section describes maintenance items and the frequencies performed by customer
engineers.
If any maintenance is noted with plural frequencies, an inspection is to be
made on an earlier schedule. Check intervals are based on the standard printer
operating conditions described below. Check the operating conditions and make
sure that maintenance and checks are performed at intervals appropriate for
the actual condition.
1. Standard usage - Printing volume : 300 K Images/month
Power on time : 200 hrs/month
Operating time : 60 hrs/month
Table 4-1. Items and intervals of periodic check and cleaning
Item
No.
Items Frequency Work time
(min.)
Note
1. Cleaning of Conveyance
rollers
400 k
images
5
2. Cleaning of covers Per visit 3
3. Checking of Drive
mechanism
400 k
images
10 If strange noise comes from
the drive mechanism due to
insufficient grease, grease it.
(Grease is for plastic)
4. Cleaning of Pressure
Roller Shaft (Sub-Tray
Paper Exit Roller C)
1,200 k
images
5 Grease is spread.