Specifications

Disassembling, Assembling & Adjustment 6-39
M M L 0 0
6.3.7. Adjusting the Opening/Closing at the Paper Exit
Applicable jigs and tools: +Screwdriver.
[Adjustment Procedures]
1. Remove the Rear Cover. (Refer to item 6.1.2 on page 6-2)
2. Remove the Top cover. (Refer to item 6.1.4 on page 6-4)
3. Remove the Cover Sheet Feeder (if installed). (Refer to item 6.2.7 on page 6-26)
4. Switch the power OFF then ON then OFF again. Then, with the paper exit closed,
confirm that the paper exit casing is firmly against the stopper section.
Figure 6-60. Adjustment of the Opening/Closing at the Paper Exit
5. If the casing is not in firm contact with the stopper,@carry out adjustment
described as follows.
6. Loosen the set screw holding the PS12 (paper exit-opening detector) bracket in
place, and adjust the bracket position as necessary.
7. Retighten the bracket set screw.
[Assembling Procedures]
1. Reinstall the rear cover, the top cover and the Cover Sheet Feeder (If installed)
reversing the procedure above.
CAUTION:
Be sure to turn OFF the MAIN AC POWER prior to performing the maintenance.