User`s guide
3-2
3.2 Removal of paper
3.2.1 Container
A message “Stacker xxx Full” is displayed on the OCP of the printer when the stacker is full of paper.
Remove paper from the designated stacker. (The lamp is slow blink during full)
[NOTE]
• Paper are outputted to the stacker whose lamp is lighting.
The Front Cover L is locked and cannot be opened while the lamp is lighting.
• To remove Paper from the stacker whose lamp does not light (no output of paper),
press the switch. Then the table starts lowering (the lamp is fast blink). Before
opening the front cover, wait until the table lowers to the bottom (the lamp is slow
blink).
• Pull the drawer unit gently so that the stack of paper is not collapsed.
1500 sheets of paper can be outputted to both the upper and the lower stackers of each container
stacker.
1. Check that the lamp is solid light.
2. After press the Open switch, check that the table is lowered to the bottom (the lamp is slow blink).
Open the front cover L and pull the drawer unit forward gently.
OG A 04
Open Switch
Front cover L
Drawer unit