User`s guide

2-3
2.2.2 Decurler function
The Decurler function has three (3) options:
AutoSelect = The engine makes the decision to turn the Decurler ON or OFF depending upon
the paper weight and mode (Simplex or Duplex) of printing.
Enable = Decurler is turned ON.
Disable = Decurler is turned OFF. This is the default setting.
The Decurler function of the Container Stacker can be set via the Operator Control Panel, as follows:
1. Select the Finisher/ Decurler menu. The following screen is displayed.
2. Select the icon.
Use the following table as reference:
Icon (Decurler mode) Auto Select Enable Disable
Print mode Simplex Duplex Simplex Duplex Simplex Duplex
Paper
Weight
Less than
28 lbs
On Off On On Off Off
(Bond) 28 lbs –
53 lbs Off Off
On (*1) On (*1) Off Off
[NOTE]
1. On = Paper passes through the decurler path; Off = Paper bypasses the decurler
path.
2. (*1) ; Paper exceeding 32lbs may not be fed through the decurler path.
(1) It is recommended not to select “Enable” when heavy paper exceeding 32 lbs is used.
OG A 02