User`s guide

1-6
1.5 Powering on the Printer
The switch of the power supply "on/off" of the printer is at the position shown in the figure below.
In case of the DDP70/92,The mark on the switch represents the characters “O” for off and “I” for on.
In case of the DDP184, when a main power supply switch is raised up ,it is shown as ON. and when it is
lowered to down, it is shown as OFF.
When the printer is powered on, the printer and the finisher go through a power-up sequence that takes
approximately 4 minutes. During the power-up sequence, the printer runs a series of internal tests.
Wait at least 5 seconds to power on the printer after powering off.
When the printer cannot be powered on, POWER OFF the printer and
wait at least 30 seconds. Then power on the printer again.
In the event of an emergency, POWER OFF the printer by turning the Power
Switch to “O”.
OG A 02
CAUTIO
N
WARNING
MAIN AC POWER switch
(In case of the DDP70 / 92)
REAR ENGINE Switch
(
USUALLY ON
)
FRONT ENGINE Switch
(USUALLY ON)
MAIN AC POWER switch (Upside is “ON”)
(In case of the DDP184)
Container stacker