User`s guide

15
2.2.2 Decurler Function
The Decurler function lets you specify if certain paper should pass through the decurler path. The
Decurler function has three modes:

AutoSelect
lets the printer determine the Decurler setting (see the table below).
 Enable turns the Decurler function on.
 Disable turns the Decurler function off.
1. To set the Decurler mode, make the following selections from the OCP:
Finisher / Decurler
2. Click on the desired Decurler option, based on the information in the following table.
Decurler mode Auto Select (Default) Enable Disable
Print mode Simplex Duplex Simplex Duplex Simplex Duplex
Less than 28 lbs On Off On On Off Off Paper
Weight
(Bond)
28 lbs – 53 lbs Off Off
On* On* Off Off
* Do not select the Enable option when using paper exceeding 32 lbs. Paper exceeding 32 lbs
cannot be fed through the decurler path.
00LOG 00LOG