User`s guide

6
1.5 Powering On the Printer
70/92 PPM
The location of the printer’s power supply switch is shown below. The marks on the switch represent
the characters “O” for off and “I” for on.
184 ppm
The entire system should be powered on and off using the main power switch shown below. To do this,
both the front and rear engine power switches must remain in the on position. If either the front or rear
engine power switch is in the off position an error will occur or the OCP display will not come up. In
this situation turn off the main power switch, turn on the power to the front and/or rear engine, then turn
on the main power switch.
Main Power Switch
Finisher
Front Engine
Rear Engine
When powered on, the printer and the finisher go through a power-up sequence that takes
approximately 4 minutes. During the power-up sequence, the printer runs a series of internal tests.
Caution:
Wait at least 5 seconds to power on the printer after powering off. When the
printer cannot be powered on, wait at least 30 seconds, then power on the
printer.
Warning!
In the event of an emergency, power off the printer by setting the power
switch to O.
00LOG