Specifications

Snap Doc 10
Taking Pictures with the Camera
1. To associate a barcode with a picture, you must scan the barcode first. To do
this, turn the camera on with the green power button.
2. Then press the Memo button.
3. Holding the camera, with it pointing at one of the barcodes on the example
dispatch ticket, so that it is shown in the center of the display, press the Left
Arrow Key.
4. It should display the barcode number that you scanned.
Note: It may have an extra character or number at the end of the barcode.
This extra character is normal, and is used as a way to check that the barcode
is valid.
5. Now press the Menu/Ok Button so that you can take the picture.
6. Take a picture how you normally would.
7. Then repeat the process of scanning the barcode, and taking a picture, for
each barcode on the page. On the example dispatch ticket, make any notes
you wish on the left hand side, so that the notes correspond to the barcodes
with the picture taken.