User guide

27
Procedure 2: If your computer still does not recognize the camera, follow the steps below.
1. Load the Caplio Software CD-ROM into your computer.
2. Connect your camera via the USB cable to your computer.
3. Click the [Start] button on the Windows taskbar to display the [Start] menu.
4. Click [Control Panel].
5. On the Control Panel displayed, click [Switch to Classic View].
The display changes its appearance and the [System] icon appears.
6. Double-click the [System] icon.
7. On the [System Properties] screen displayed, click the [Hardware] tab.
8. On the [Hardware] tab page displayed, click the [Device Manager] button.
9. On the [Device Manager] screen displayed, click [+] on the left side of [Imaging devices]
to open.
10. Check whether or not there is an unknown device symbol (!) indicated for [Caplio XX]. If
there is, right-click the unknown device symbol to display the menu and select [Update
Driver].
11. Windows will display the [Hardware Update Wizard] screen.
At this point, check that the Caplio Software CD-ROM is inserted in your computer. If the
CD-ROM is not inserted, insert in your computer.
12. Make sure that [Install the software automatically (Recommended)] is selected, and then
click [Next].
13. When the [Completing the Hardware Update Wizard] screen appears, click [Finish].
14. Click the [×] (Close) button to close the [Device Manager] screen.
15. Click [OK] to close the [System Properties] screen.
16. Click the [×] (Close) button to close the Control Panel.
The driver is installed and your computer recognizes the camera correctly.