User guide

17
Transferring Images in Mass Storage
Mode
Caution
Mass storage mode is not available on this camera if
you are using Mac OS 8.6.
1. Set [USB CONNECTION] to
[MASS STR] on the SETUP
menu.
2. Make sure that the camera power
is off.
3. Connect the accessory USB
cable to a USB port of your
computer.
4. Connect the USB cable to the
USB terminal of your camera.
Your camera turns on.
Your computer automatically reads the
file necessary for recognizing the camera
as a drive.
After this preparation, the camera is
displayed as a drive on the Desktop.
5. From the displayed drive, copy a
file to the desired location.
The figure below shows the folder
configuration in the drive.
When the contents of the internal
memory are displayed, the drive name is
[RICOHDCI].
Caution
Do not turn off the camera or disconnect the USB cable
during image transfer.
• If a file with the same name already exists at the
destination, it is overwritten. If you do not want the file
to be overwritten, rename the file or transfer data to
another folder.
• When an SD memory card is loaded, its files are
displayed. Otherwise, files in the internal memory are
displayed.