Operating instructions

Troubleshooting
78
5
Hardware Problem
Wireless Card
An error has occurred in the
802.11b Interface Unit.
Reset the 802.11b Interface
Unit if the same message ap-
pears after turning the power
off and then back on again. If
the same message still ap-
pears, contact your sales or
service representative.
HDD Full The maximum HDD area size
for form/font has been ex-
ceeded.
Delete the disused form/font
types.
HDD Full The optional Hard Disk Drive
is full. The sample print job or
locked print job to be sent
from the computer is too large
to store.
Delete any unnecessary stored
files.
HDD Not Installed You cannot print the sample
print and the locked print
jobs, because the optional
Hard Disk Drive is not in-
stalled.
Install the Hard Disk Drive.
See “Hard Disk Drive Type
2600” in the Setup Guide.
Hex Dump Mode The printer is in Hex Dump
Mode.
Wait for a while. If the "Hex
Dump Mode" message does
not change, on the panel dis-
play press {
{{
{On Line}
}}
} to return
to the "Ready" condition.
I/O Buffer Overflow There is too much data for the
I/O Buffer to handle.
Make sure the interface cable
is inserted into the printer and
your computer securely.
Make sure the interface cable
is not damaged or broken.
Increase the size of the I/O
buffer.
Invalid Password
Try Again
The password was not en-
tered correctly.
Wait for two seconds until the
previous display appears.
Then enter the password cor-
rectly.
Invalid Password File Protect-
ed
An incorrect password has
been entered more that 10
times, the file is now protected
until an administrator can un-
lock it.
The file is now protected until
an administrator can unlock
it.
Messages/Second messages Description Solution