Service manual

30 July, 2001 DRIVE UNIT
3-41
Replacement
Adjustment
3.10.2 DEVELOPMENT CLUTCHES
1. Rear cover (☛ 3.3 EXTERIOR COVERS)
2. Swing out the controller box (☛ 3.9.1 MOVING THE CONTROLLER BOX OUT
OF THE WAY).
3. K, C, and M drum gears, with the flywheels (☛ 3.10.1 REGISTRATION
CLUTCH)
4. Y drum gear (! x 1) (☛ 3.10.1 REGISTRATION CLUTCH)
5. Lower gear guide (☛ 3.10.3 DEVELOPMENT DRIVE MOTOR - CMY)
NOTE: To remove the B, Y, and C development clutches, you do not have to
remove the lower gear guide.
6. Development clutches [A] (! x 1 for each, # x 1 for each)
NOTE: When reassembling the machine, please route the development clutch
cables as shown in the bottom half of the illustration, or problems will
occur. If the cables are routed as shown in Case 1, the black and yellow
development clutch cables are connected the other way around, causing
an abnormal image (no black or yellow). If the cables are routed as shown
in Case 2, the power lines for the clutches are connected incorrectly,
causing damage to the BCU board.
G060R819.WMF
G060R825.WMF
[A]
Case 1 Case 2