Service manual

30 July, 2001 ELECTRICAL COMPONENTS
3-37
Replacement
Adjustment
3.9.3 CONTROLLER AND BCU
NOTE: After replacing the BCU or controller, remove the NVRAM on the old board
and install it on the new board.
1. Controller [A] (! x 2)
2. Option bracket [B] (! x 2)
3. Rear cover [C] (☛3.3 EXTERIOR
COVERS)
4. Cover bracket [D] (! x 3)
5. Inner bracket [E] (! x 2)
6. Connector cover [F] (! x 1)
7. BCU [G] (! x 8, " x 23)
NOTE: After replacing the BCU or controller,
remove the NVRAM on the old board
and install it on the new board. If the
NVRAM on the old board is defective,
replace the NVRAM (☛ 3.9.4 NVRAM
REPLACEMENT PROCEDURE).
G060R701.WMF
G060R702.WMF
G060R703.WMF
[A]
[C]
[B]
[D]
[E]
[F]
[G]