Service manual

FUSING 30 July, 2001
3-30
3.8.4 FUSING BELT UNIT
1. Upper oil supply/cleaning unit [A] (! x 3)
NOTE: When reassembling, secure 3 screws temporarily first. Then, tighten the
screws in the following order (➀→➁→➂). If the screws are not tightened in
this order, the drive gears are not properly engaged, causing mechanical
noise.
2. Lower paper guide plate [B] (Step screw x 1, ! x 1)
NOTE: When reassembling, insert the hook [C] into the lower cover groove [D].
Otherwise, the plate bends slightly and the pick-off pawls may damage the
pressure roller. After reinstalling the plate, push the central portion [E]
down to make sure that the plate is in position.
G060R502.WMF
G060R802.WMF
[A]
[B]
[C]
[D]
[E]
➂
➁
➀