Service manual

30 July, 2001 MACHINE INSTALLATION
1-5
Installation
1.4 MACHINE INSTALLATION
Refer to the Operating Instructions for details.
If the customer has a service contract, change the settings of the following SP
modes depending on the contract type.
Item SP No. Function Default
Meter charge SP5-930-1 Specifies whether the meter charge
mode is enabled or disabled.
Meter charge mode enabled:
• The Counter menu appears
immediately after the Menu key is
pressed.
• The counter type selected by the
counting method (SP5-045-1) can be
displayed with the Counter menu.
• The counter values can also be
printed with the Counter menu.
• The selected counter starts from a
negative number.
Meter charge mode disabled:
• The Counter menu is not displayed.
• The total counter starts from 0.
Off
Counting method SP5-045-1 Specifies whether the counting
method used in meter charge mode is
based on developments or prints.
Important:
This SP can only be done before the
negative counters are reset with SP7-
825-001
Developments
A3/11" x 17"
double counting
SP5-104-1
Specifies whether the counter is
doubled for A3/11" x 17" paper.
No: Single
counting
PM warning
display 1
SP5-930-3 Specifies whether the PM warning for
PCUs and development units is
displayed when the replacement time
arrives.
Type 1: Displayed
Type 2: Not displayed
Type 1
PM warning
display 2
SP5-930-4
to
SP5-930-5
Specifies whether the PM warning for
the paper feed roller and transfer unit
is displayed.
Off:
Fax No. setting SP5-812-2 Programs the service station fax
number.
The number is printed on the counter
list when the meter charge mode is
selected, so that the user can fax the
counter data to the service station.