Operating instructions

Attaching the USB Host Interface Board Type A

D Fully insert the USB host interface board.

E Tighten the two screws to secure the USB host interface board.

Check the USB host interface board is inserted firmly to the controller board.

Note

❒ After finishing installation, check the USB host interface board is installed

properly: print the configuration page from the [List/Test Print] menu. If it

is installed properly, you will see “USB Host” for “Device Connection” on

the configuration page.

❒ If the USB host interface board is not installed properly, reinstall it follow-

ing this procedure. If you cannot install it properly even after attempting

reinstallation, contact your sales or service representative.

❒ You can connect the USB cable from a digital camera to the USB host inter-

face board. For details, see p.61 “Connecting a digital camera”, or Software

Guide.

Reference

For details about printing the configuration page, see “Test Printing”,

Quick Installation Guide.

AQC042S

AQC044S