Operating instructions

Attaching IEEE 1284 Interface Board Type A

D Fully insert the 1284 interface board.

Confirm that the 1284 interface board is firmly connected to the controller

board.

E Tighten the two screws to secure the 1284 interface board.

Note

❒ Use the supplied adaptor to make the connection with the computer.

❒ After finishing installation, you can check the 1284 interface board is prop-

erly installed: Print the configuration page from the [List/Test Print] menu.

If it is installed properly, “Parallel Interface” will appear for “Device Con-

nection” on the configuration page.

❒ If the 1284 interface board is not installed properly, reinstall it following

this procedure. If you cannot install it properly even after attempting rein-

stallation, contact your sales or service representative.

Reference

For printing the configuration page, see “Test Printing”, Quick Installation

Guide.

AET102S

AQC103S