Operating instructions

Attaching IEEE 802.11b Interface Unit

F Attach the antenna to the card with the label facing down and the uneven

side of the antenna facing up.

G With the antenna and the indented end toward you, slowly insert the inter-

face card until it stops.

H Hold the antenna cap with the cut off corners towards you and fit it over the card.

Note

❒ After finishing installation, you can check the 802.11b interface unit is

properly installed: Print the configuration page from the [List/Test Print]

menu. If it is installed properly, “IEEE 802.11b” will appear for “Device

Connection” on the configuration page.

❒ If the 802.11b interface unit is not installed properly, reinstall it following

this procedure. If you cannot install it properly even after attempting rein-

stallation, contact your sales or service representative.

Reference

For printing the configuration page, see “Test Printing”, Quick Installation Guide.

AET096S

AQC097S

AQC098S